<
Environmental Reference Standards
<
Retention Time Standards
Inlet Liners for Agilent GCs: CarboFrit®-Packed
“Restek sent us some carbon material (CarboFrit® packing) with the suggestion to test it as liner packing. Initially, I didn’t even want to try it because carbon is usually highly retentive and catalytically active. As we nevertheless gave it a chance, we were highly surprised..it exhibited low retentive power and good inertness.”excerpt from:“Sample Evaporation in Hot GC Injectors,”Dr. Konrad Grob,The Restek Advantage, Winter 1996.
- Highly inert.
- Extends analytical column lifetime.
- Enhances reproducibility of split and splitless injection.
- Uniform pore size and consistent packing density guarantee consistent flow through the liner.
- Easy to install in any liner with an ID >3.5mm when using puller-inserter tool listed below.*
Add the corresponding suffix number to the liner catalog number.
Instruction Sheets:
*Liners with IDs less than 3.5mm are difficult to pack. We will pack them on a custom basis (minimum neck ID of 2mm required).
