Benvenuti nel nuovo sito Restek.com! Fate un tour e sentiti liberi di inviarci un vostro riscontro

Il tuo browser web non sarà più supportato da Restek.com a partire dal 30 giugno 2021.
Per evitare qualsiasi interruzione di accesso o alle nostre funzionalità, installa subito un browser web di generazione. Per saperne di più.

Replacing a PTFE Frit in an Agilent LC Pump

  • Condividi:

Description

The PTFE frits in your Agilent LC pumps will need to be replaced from time to time as part of a routine maintenance program. Over time, these frits will accumulate contamination and can then start to increase system pressure. Replacing them is pretty straightforward—it only takes about ten minutes, and we can show you how.

Additional Resources

 

Restek Recommended Tools & Parts

 

Transcript

Hi, everyone. Thanks for joining us for this Restek Tip. Our topic today is PTFE frit replacement in the Agilent series pumps. Both the 1100 and the 1200 pumps have a PTFE frit in the purge valve. This helps keep particulate matter from seal ware or any particles in the mobile phase from getting into the pump. The recommended replacement schedule for these frits is every three months, but if you happen to notice an increase in system pressure and have isolated it to the pump, this is a good place to check. Replacing the frit is very easy. We're going to go through the steps with you now.

First, open the purge valve to release the pressure then remove the outlet capillary and drain lines. Next, unscrew the valve with the 14 mm flat wrench provided in the pump accessory kit. Remove the plastic cap and the gold seal, being careful not to damage the seal in any way. While they are reusable for several times, you want to always inspect it and make sure there's no particulates or signs of wear. If it's dirty or misshapen in any way, don't put it back into the pump, because there's a good chance that it will leak. Use tweezers to remove the existing frit. Install a new frit with the slotted end pointing up. This ensures that the area of the frit with the most surface area is facing the direction of solvent flow. Replace the gold seal on the plastic cap. Install the completed assembly back onto the pump making sure to orient the valve so the drain stem is pointing down. Hold the valve in place while tightening with the wrench about a quarter turn past hand-tight. Then reattach the drain line and outlet capillary. It really is that simple. It takes about ten minutes, and it's something you can easily do yourself to keep your work flowing.

Thanks for joining us. Watch for more tips from your friends at Restek.

GNAV3646-UNV

Video Correlati

Changing a Detector Lamp

Guarda il video

LC Tubing—Cutting & Installation

Guarda il video

LC Tubing & Fitting Choices

Guarda il video

Articoli Correlati

Restek LC Columns and Accessories

Leggi l'articolo

Building up pressure on HPLC?

Leggi l'articolo